|
04-30-2019, 05:08 PM
|
#1 |
|
Registered User
Join Date: Dec 2018
Location: Nj
Posts: 2
|
Shimmies
Can’t get rid of my shimmie at 55
4-6 bel tech lowering kit 86 c10 short bed flip kit in rear Rear pinion angle is higher than trans angle What am I doing wrong . |
|
|
|
04-30-2019, 05:47 PM
|
#2 |
|
Registered User
Join Date: Dec 2012
Location: Temple City
Posts: 3,566
|
Re: Shimmies
Do your shocks have any stroke left or is it greatly reduced? You could be bottoming out on the shocks, and this may induce shimmies.
Are you sitting on the bump stops? What is your alignment like? Check your rear end mounting bolts. Typically your trans should angle down at the same angle your rear end angles up. Home Depot or equivalent have a nice angle finder I have used before to set up rear ends with. |
|
|
|
|
04-30-2019, 07:31 PM
|
#3 |
|
Post Whore
  
Join Date: May 2015
Location: Alabama
Posts: 14,597
|
Re: Shimmies
welcome...
what is your driveline angles? trans angle and diff angle?
__________________
Mongo...aka Greg RIP Dad RIP Jesse 1981 C30 LQ9 NV4500..http://67-72chevytrucks.com/vboard/s...d.php?t=753598 Mongos AD- LS3 TR6060...http://67-72chevytrucks.com/vboard/s...34#post8522334 Columbus..the 1957 IH 4x4...http://67-72chevytrucks.com/vboard/s...63#post8082563 2023 Chevy Z71..daily driver |
|
|
|
05-01-2019, 10:01 AM
|
#4 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,917
|
Re: Shimmies
Driveline angles shouldn't be that far off when using a typical kit like Belltech.
First... Double check the fasteners are tightened correctly up front. 2nd.... Re-Check that your wheel bearings are correctly secured/tightened & there is no play. What were the alignment specs after lowering?
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
05-04-2019, 06:28 PM
|
#5 |
|
Registered User
Join Date: Dec 2018
Location: Nj
Posts: 2
|
Re: Shimmies
Hey guys
Thank you for your response Sorry i took this long to respond My dog tore his ACL So truck is on jack stands pinion angle is 0 rear of driveshaft 3 up Trans at 0 front of drive shaft down 2 The shake is coming from rear Balanced all tires twice Rear is all tight shocks are new with the lowering kit Alignment was done truck drives nice and straight handles great till I get to 55 I have a 700r4 trans in it and 4 gear is not hooked up yet Could that be a problem or converter or flywheel Axels were replaced driveshaft is new |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
