So I finally got rid of one project and have the additional resources to throw at my daily '64 c30. Dropping a 5 speed NV4500 in next week and have been trying to work out a good solution to the stance. I'm thinking lowering spindles for the front since that would likely be the best ride? (Outside of bags) and I've been looking at doing a flip kit on the rear trying to retain the 10 million lb leaf springs for functionality.
There is a lot out there for the 1/2 ton c10 but I have been running into difficulties trying to figure out a solution for the c30.
Looking to lower 2.5-3" in the front and rear.
I'll be reconfiguring the bed and tool boxes soon so I'd like to try and tackle the lowering while I have extra room to move around. Thanks for the help and definitely appreciate everyone's posts in this forum. I've learned more in six months on this site than that entire college career, haha.
08-23-2015, 11:22 PM
Threaded Mode