|
04-19-2016, 05:57 PM
|
#1 |
|
Registered User
Join Date: Nov 2014
Location: Buckeye, Az
Posts: 122
|
Drive shaft
I installed a CPP crossmember, transmission crossmember and carrier bearing on my LWB 69 c10. The drive drive shaft is the one that came off the truck and worked fine when everything was stock. Now with the new parts the rear driveshaft seems to be to short, leaving the carrier bearing to far from the crossmember to bolt up the bracket. Any solutions to this would be welcomed.
Thanks, Mondo |
|
|
 |
| Bookmarks |
|
|
Linear Mode
