Clutch /scattershild help..

[FRENCHBLUE72]

I am gonna try to put the motor and tranny in project old school this x-mas break,but need help on a few thing's.. What size flywheel and clutch /pressure plate should I be looking for.. Also what should I do about the clutch linkage do i need a aftermarket clutch fork?? Hs anybody here gone hydrolic instaed of mechanical?? Need some input and idea's.. Any help is greatly appreciated..
Thank's Luke.

[jhwkns]

I'd use the stock clutch linkage if possible. Switching to hydraulic can be a real chore. Make sure it's going to clear your exhaust. There might be a problem if you have headers.

Do you have the proper flywheel / starter combo for the scattersheild? It could be a determining factor on which clutch you need

Starters for a manuel trans. usually bolt to the bellhousing instead of the block.

What are you using for a transmission mount?

Chances are a stock clutch will work for you.

Good luck with your project Luke.

[FRENCHBLUE72]

Thank's I do not have anything but tranny and scatter shield.. I do have a starter that fit's into the hole of the scatter shild. Stock tranny mount seem's to work fine and I don't have exhaust at all... Thank's for the input..

[FRENCHBLUE72]

Ohh ya I am gonna stay away from the hydro linkage also... Need to dig around for the stock z-bar and other assorted rod's..