running fuel injection ,where did you put computer

[dilling]

Where did you mount the computer

[jkade]

Took glove box out and mounted it on the firewall.

[billyjo]

Same with mine, put it into the glove box.

[Deuce]

Used the extended Painless harness and mounted it under the drivers seat.

[combustion]

as far away from heat as possible id asume. on my sand rail its under my seat.

[BobbyK]

See the 3 screws on the flat part of the glovebox liner,it's mounted on the backside of it(wire hanging down had not been connected up yet.

[Kid]

Put mine under seat too, Speartech made my harness to length needed

[Custom 68]

Originally Posted by Deuce

Used the extended Painless harness and mounted it under the drivers seat.

same here but under the passenger seat...

[Ackattack]

In my gmc, it is located under the custom center console.

In the 68 chevy, I will mount it under the hood. The GenIII motors can have the computer mounted under the hood....that's where they're at from the factory.

[bodydropped68]

Originally Posted by dilling

Where did you mount the computer

i mounted mine on the passanger side under the bench seat along with the spark control module,fuel pump & run relays and fuses with the long painless harness.that was 58,000 miles ago without any problems.

[bigo181979]

Where did you run the wires through, fire wall or other and how big of a hole did you have to cut to get the big plug for the computer through? Got to see what others have done so I know what to do when I get to mine.

[clay68c10]

Mine's under the left side of the dash. I used the stock 89 thru-firewall square plastic thing from the donor truck to run the wiring inside.

[71swb4x4]

I used the stock wiring harness and mounted it under my middle seat.