|
11-09-2004, 03:00 PM
|
#1 |
|
Life is a gamble
Join Date: Oct 2003
Location: Lee's Summit, MO
Posts: 796
|
Crossmember Questions
Are there supposed to be exhaust cutouts on the crossmember?
I haven't had time to mess with my truck for awhile, so today I was poking around underneath it and noticed this:  I'm not sure why I never noticed before. Is this a bad thing? A good thing? Thanks  Art
__________________
1970 Orange CST C-10 w/350, posi, Longbed The torpid artist seeks inspiration at any cost, by virtue or by vice, by friend or by fiend, by prayer or by wine. -- Ralph Waldo Emerson Last edited by ACES; 11-09-2004 at 03:07 PM. |
|
|
|
11-09-2004, 03:11 PM
|
#2 |
|
Registered User
Join Date: Apr 2004
Location: South Texas....the Valley
Posts: 199
|
Most likely won't hurt anything. If it were me, I would try to cut a "round" area big enough to accomodate the pipe without it rattling against the X-Member and weld a circular reinforcement around the hole I cut out. The welded part is most likely overkill....but thats just the way I am. A good round hole in that area won't detract much from its strenght....just stay away from the bends at the top and bottom of the X-Member.
|
|
|
|
|
11-11-2004, 04:13 AM
|
#3 |
|
Stepsides Are Bedder
Join Date: Feb 2004
Location: Norco, CA
Posts: 238
|
The only thing I cringe about is that the brake and fuel lines will be running right next to the exhaust pipe in that area...
|
|
|
|
|
11-11-2004, 10:14 AM
|
#4 |
|
Life is a gamble
Join Date: Oct 2003
Location: Lee's Summit, MO
Posts: 796
|
hmm, your right about that, they are only a few inches from each other.
__________________
1970 Orange CST C-10 w/350, posi, Longbed The torpid artist seeks inspiration at any cost, by virtue or by vice, by friend or by fiend, by prayer or by wine. -- Ralph Waldo Emerson |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
