|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-10-2008, 02:08 PM
|
#1 |
|
Registered User
 Join Date: Jan 2008
Location: Spokane WA
Posts: 254
|
68 292 rebuild --> Push rod covers?
Just finishing up a few things on this inline 6 and after looking at my push rod covers trying to decide to clean them up or check out some custom ones I figured I would ask and see if anyone could point me in the direction of some aftermarket/custom covers of some quality? If not then I shall clean them up, I know I have seen some nifty ones at some different shows although searching around I cannot seem to find any.
Thank ya Skez |
|
|
|
08-10-2008, 04:40 PM
|
#2 |
|
Active Member
Join Date: Jul 2007
Location: Centrally located between Houston, Austin and Waco. BCS area.
Posts: 7,947
|
Re: 68 292 rebuild --> Push rod covers?
|
|
|
|
|
08-10-2008, 08:49 PM
|
#3 |
|
I am a Referee of life.
Join Date: Jun 2000
Location: Greensboro N.C.
Posts: 13,993
|
Re: 68 292 rebuild --> Push rod covers?
All 6 cyl performance parts are pricey.I keep my eyes open at swap meets and such but that stuff is rare.I estimate the cost of a mild performance rebuild/dress-up on a 6 to be about double a small block.
__________________
The 47-present Chevrolet and GMC Truck Message Board Network,it's owners,moderators,members,and associates of any type should not be held responsible for my opinion. You can't fix stupid,not even with duct tape. "My appearance is due to the fact that "GOD" does punish you for having too much fun!" Barrett-Jackson has perfected alchemy,they make rust into gold! "You can lead a horse to water but you can't saddle a duck" "Cleverly disguised as a 'Responsible Adult' "Sometimes your Knight in shining armor is just a retard in tinfoil" |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
