|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-06-2007, 06:33 PM
|
#1 |
|
Registered User
Join Date: May 2007
Location: Cedar Park, TX USA
Posts: 52
|
De-pinning steering column connector
I bought a Painless wiring harness for my '72 SWB. I am trying to get the pins out of the original factory "half moon" connector since I need to re-use it with the Painless harness. The manual for the harness says to use a small flat head screw driver or paper clip, insert it in to the top of the opening, opposite end of where the wire goes in, and pull the wire out. For the life of me I can not get the connectors to come loose. Its like they are glued in. I tried sparying some grease on them wit no luck. Does anyone have any tricks for getting theses connectors out?
__________________
Jeff's Current Vehicles: 1989 Turbo Trans Am Pacecar "Life is like racing, it goes by fast and has many turns" |
|
|
| Bookmarks |
|
|
Threaded Mode