The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-03-2017, 01:26 AM   #1
Cadillac Kid
Registered User
 
Cadillac Kid's Avatar
 
Join Date: Jun 2016
Location: Redondo Beach, CA
Posts: 72
1974 c10 New Reman Brake Booster/Master Low Pedal (Not Spongy)

Hello everyone.


I hate having to do things twice,but I'm afraid thats what I'm going to have to do. When I got my 74' it had been sitting for 10 years. The brake booster/master were completely shot. My truck has factory HD Brakes (JB5) Dual diaphram booster. I replaced the booster/master with a Orilleys reman unit. I've used them in the past with no issues. I bench bled the master, bled the entire system about 4 different times, all brake parts and hoses are brand new with no leaks in the system. Here is where it gets complicated to explain, so please bear with me. The pedal feel is good, but it is too low to the floor. In other words, the hydraulic side of the brakes feel fine, it honestly feels like the booster is giving to much assist causing the low pedal. When you push the brakes it stops the truck sufficiently, but the pedal goes almost all the way to the floor. I have had a hand full of old cars and I know what spongy brakes feel like, this is not it.

Other symptoms are when the engine is idling and you push the brakes, the rpm increases. I am not sure if this is normal. I have never had a car that did this. The 2nd thing is that, in a normal car when you shut off the engine and push the brakes down a few times the pedal eventually gets hard, correct? Well in the truck when you pump the brakes after shutting the engine off, the brake pedal never hardens up and has the same consistency with each pump. And there is a hissing noise from the booster when doing this. Any ideas?

I've been told that my culprit could be the length of the pushrod between the booster and the master. But arent the pushrods on these GM booster non adjustable? I removed it when I purchased the unit to look at it, when I put it back in it sat at the same depth, no problems. Something is just not right.
The unit I bought has a limited lifetime warranty and I'm tempted to just rip it all out again and return it.

Completely unrelated, we had a small fire at my house yesterday, nobody hurt, all water damage, house is uninhabitable but I'll have to go back because I know the receipt for the booster is in there somewhere.
Problems like this are so hard to diagnose over the internet.
If you actually read this far I applaud you, and thank you!
Ah, life..

-Gavin
__________________
Keep on truckin'
Cadillac Kid is offline   Reply With Quote
 

Bookmarks

Tags
1974, brakes, c10, chevy


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:49 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com