|
10-04-2018, 07:52 PM
|
#1 |
|
Registered User
Join Date: Oct 2018
Location: Clearfield
Posts: 1
|
Help
Hello, I have a 1970 Chevrolet C10. I have had it for about a year and a half now and I have run into an issue. I was checking my vin identification(the 5 digit code in the beginning) and my trucks identification number indicates that my truck is a step side, even though it's a fleet side. My question is did they make 8 foot step side beds and is it possible they did a swap? It concerns me cause I want to restore my truck to factory defaults and if this is true I want to know so I can try and find an 8 foot step side.
|
|
|
|
10-04-2018, 08:00 PM
|
#2 |
|
Senior Member
 
Join Date: Apr 2016
Location: Cypress, TX
Posts: 3,811
|
Re: Help
The VIN does not contain indication of step side or fleet side. Can you post a picture of your sticker on the glove box door?
|
|
|
|
10-04-2018, 08:27 PM
|
#3 |
|
Senior Member
Join Date: Jan 2001
Location: Orem, Utah
Posts: 7,954
|
Re: Help
Look for the SPID (service parts identification decal) on the inside of the glovebox door. That's going to give you a lot more information.
__________________
I have sworn upon the altar of God, eternal hostility against every form of tyranny over the mind of man. - Thomas Jefferson |
|
|
|
|
10-05-2018, 07:04 AM
|
#4 |
|
Senior Member
Join Date: Aug 2004
Location: Centennial, CO
Posts: 2,979
|
Re: Help
They did make an 8’ step side bed. Very possible it has been swapped.
Welcome to the board!
__________________
ClusterTruck: 68 C10 Bought in 89, wrecked in 03. Slow low $ rebuild started '17. 6.0 & TKO http://67-72chevytrucks.com/vboard/s...d.php?t=788602 93 K1500 Short Step, 350, NV4500, EBL flash ECU. Vortec heads & roller cam someday... 05 Jeep Wrangler Unlimited. 3” lift & 6-speed 02 E320 the insurance total “free car” 13 Tahoe LTZ |
|
|
|
 |
| Bookmarks |
| Tags |
| 1970, c10, fleetside, stepside |
|
|
Linear Mode
