![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Jul 2006
Location: Central PA
Posts: 12,201
|
Rocker measurement and angles?
I'm trying to figure out the correct spacing and height of this rocker... any help? How wide is the weather stripping gap suppose to be? How far below the floor it is suppose to drop off? I know that the front of mine needs to some down 3/16" or so...
![]() ![]() ![]()
__________________
The Garage: 1968 K-10 SWB - "Project Money Pit" 1996 Z-71 - "huntin rig" 1969 C-10 LWB (SOLD) "Project flip that truck or else" 1993 Passport, F@rd 1-ton (SOLD)"Project Cousin Eddie" My Garage Build "The 1,000 footer" |
![]() |
![]() |
![]() |
#2 |
Rods
![]() Join Date: Nov 2002
Location: Bryan, TX
Posts: 1,398
|
Re: Rocker measurement and angles?
if it were me I would install the door and get my gaps right. take a couple of clams on the pinch weld when its right. mark it then weld it in
|
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Jul 2006
Location: Central PA
Posts: 12,201
|
Re: Rocker measurement and angles?
I have the door installed and the gaps aren't bad. The front needs to come down about 1/8 - 3/16" or so.
__________________
The Garage: 1968 K-10 SWB - "Project Money Pit" 1996 Z-71 - "huntin rig" 1969 C-10 LWB (SOLD) "Project flip that truck or else" 1993 Passport, F@rd 1-ton (SOLD)"Project Cousin Eddie" My Garage Build "The 1,000 footer" |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: Nov 2003
Location: Brookings, SD
Posts: 10,497
|
Re: Rocker measurement and angles?
His door is installed. He is asking about the inside gaps.
__________________
Some people are like slinkies, they aren't good for anything, but you can't help but smile when you see one tumble down the stairs. |
![]() |
![]() |
![]() |
Bookmarks |
|
|