Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
03-06-2017, 08:50 PM | #1 |
Registered User
Join Date: Jul 2011
Location: Valley Center, Ca
Posts: 277
|
Im stumped! Truck wont start
Went to start my 69 C10 with 350 crate engine and it wont start. Acts like I have plug wires crossed. Ran perfectly yesterday. Only work since yesterday was replacing valve cover gaskets. I have checked the plug wiring firing order 6 times and it is correct. Truck has an HEI about 6 years old. Will pull cap off tomorrow. Between now and then though I would see if anyone had any thoughts on what could be the problem.
|
03-06-2017, 08:54 PM | #2 |
Moderator
Join Date: May 2007
Location: Southern Cal
Posts: 20,016
|
Re: Im stumped! Truck wont start
Make sure all wires are seated at the cap and at the plugs
__________________
1972 C/10 Cheyenne Super SWB. Restored, loaded, slammed. 1968 C/10 50th Anniversary LWB. Unrestored, stock, daily driver/work truck. RIP ElJay RIP 67ChevyRedneck RIP Grumpy Old Man RIP FleetsidePaul |
03-06-2017, 08:58 PM | #3 |
Registered User
Join Date: Jul 2009
Location: huntington beach ca
Posts: 341
|
Re: Im stumped! Truck wont start
Make sure the distributor is not loose it have moved on you
|
03-06-2017, 09:21 PM | #4 |
Registered User
Join Date: Jul 2011
Location: Valley Center, Ca
Posts: 277
|
Re: Im stumped! Truck wont start
Knocked the Bat wire loose from the HEI when I changed the valve cover gasket on the drivers side. DUH!
|
03-06-2017, 09:27 PM | #5 |
Registered User
Join Date: May 2011
Location: mich
Posts: 655
|
Re: Im stumped! Truck wont start
see you beat me to the punch
Last edited by hjewell2; 03-06-2017 at 09:33 PM. |
Bookmarks |
|
|