Damper pulley question - The 1947 - Present Chevrolet & GMC Truck Message Board Network

*wolfthing2000* · 10-23-2006, 10:04 PM

I just removed the alternator and related stuff from the front of a 350 that I am pulling out of a 69 4x4. Non of the engine is original, it is the 3rd engine in the truck ( the PO thought)!! I was going to use the pulleys and brackets, power steering etc. on my new 383 going back in. After removing the alternator I was able to lign of sight the power steering pump pulley to the damper pulley front groove. The damper pulley is 3/8 of an inch to the rear from the power steering pump pulley. It worked that way and everything seems tight. What is up here???? It is the short water pump by the way.
Thanks

10-23-2006, 10:04 PM	#1
wolfthing2000 Account Suspended Join Date: Oct 2004 Posts: 1,276	Damper pulley question I just removed the alternator and related stuff from the front of a 350 that I am pulling out of a 69 4x4. Non of the engine is original, it is the 3rd engine in the truck ( the PO thought)!! I was going to use the pulleys and brackets, power steering etc. on my new 383 going back in. After removing the alternator I was able to lign of sight the power steering pump pulley to the damper pulley front groove. The damper pulley is 3/8 of an inch to the rear from the power steering pump pulley. It worked that way and everything seems tight. What is up here???? It is the short water pump by the way. Thanks



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.