The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1947 - 1959 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 09-16-2008, 12:34 PM   #1
Farnuckel
Farnuckel
 
Farnuckel's Avatar
 
Join Date: May 2005
Location: Exeland, WI
Posts: 163
Transmission Identification!

I've got a 57 Chevy 3600 with a 235 I6 from a newer vehicle, and a transmission i'm not convinced is original.

It's a 4-speed, with the ratcheting squeeze-brake on the output. On the top of the driver's side, it says GM2 591568. On the passenger side, it says J1955.

I'd like to get a gasket set for this, and I need some parts for the shift handle where it enters the transmission, or a new shift handle. I can't seem to find enough information to know what to get.

Please Help!

Thanks
Farnuckel is offline   Reply With Quote
Old 09-17-2008, 06:46 PM   #2
OrrieG
Registered User
 
OrrieG's Avatar
 
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
Re: Transmission Identification!

The part number you have is for the shift housing, the main case should have another number. The date code is September (J) 19th, 55 or 65, usually there are only three numbers. That tranny was the main stay 4 speed from 47 to early 70's. Early models had 4.6" input bearing retained, later 5.125" retainers. I think the input shafts were different sizes too. I thing the shifters are all the same. Let me quess that the tabs on the cone that hold the shifter in place are broken?? Common problem. You can still probably go to the Chevy dealer and get the gasket set since it is so common. They will take a lot of abuse, I had one in my 59 that was growling when I put it in and growled for 10 years, about 40K miles but never broke.

Last edited by OrrieG; 09-17-2008 at 06:48 PM.
OrrieG is offline   Reply With Quote
Old 09-25-2008, 01:46 PM   #3
Farnuckel
Farnuckel
 
Farnuckel's Avatar
 
Join Date: May 2005
Location: Exeland, WI
Posts: 163
Re: Transmission Identification!

Thanks for getting back to me. What broke is the cylinder that houses the metal tab that moves the gears. The roll pin is WAY worn out too. it's functional, but VERY sloppy, and i fear may brake more. I ended up making the gaskets from a gasket material I had. Hopefully they hold up. Would I put 80/90 Gear Lube in there? or ATF? I was guessing gear lube.
Farnuckel is offline   Reply With Quote
Old 09-25-2008, 03:42 PM   #4
solidaxel
Registered User
 
solidaxel's Avatar
 
Join Date: Dec 2002
Location: Cactus Patch So. Az
Posts: 4,749
Re: Transmission Identification!

80-90W should remove the heat,
You could use RTV for gaskets in a pinch if you let it set up a bit, works good on the rear end cover also!
__________________
53 TuTone Extended Cab 350 4-Spd 3:08 (SOLD)
53 Chevy Moldy pearl green ZZ-4 4L60E 9" 3:25
55 GMC 1st Black Mll (ZZ4) ZZ6 TKO 600 5 sp 3:73
62 Solidaxle Corvette Roman Red (327
340hp 4spd 3:36) C4 & C5 suspension tube chassis
LS 3 4L70E
65 Corvette Coupe 327 350hp 4spd 4:11
78 Black Silverado SWB (350/350) 5.3 & 4L60E 3:42
2000 S-Type 3.0 (wife cruiser)
2003 GMC SCSB 5.3 4L60E 3:42
solidaxel is offline   Reply With Quote
Old 09-25-2008, 04:08 PM   #5
1-ton of fun
polishing a turd
 
1-ton of fun's Avatar
 
Join Date: Dec 2004
Location: houston, tx
Posts: 674
Re: Transmission Identification!

i think those are the sm420 but i may be wrong
__________________
59 chevy apache 31 4x4 - my project: http://67-72chevytrucks.com/vboard/s....php?p=8668512

53 buick special - straight 8 sled - blow through turbo
47 gmc - flatbed hot rod build
99 ford econoline e350 - 4x4 converted family roadtrip/overlanding rig AKA 'Monstervan' AKA 'Daddy-Van'
1-ton of fun is offline   Reply With Quote
Old 09-30-2008, 01:07 PM   #6
Farnuckel
Farnuckel
 
Farnuckel's Avatar
 
Join Date: May 2005
Location: Exeland, WI
Posts: 163
Re: Transmission Identification!

Looks like it could be a Muncie SM420, from what i'm finding on the internet. Thanks!
Farnuckel is offline   Reply With Quote
Old 09-30-2008, 02:59 PM   #7
sneakysnake
It's a catastrophic success.
 
sneakysnake's Avatar
 
Join Date: Jan 2003
Location: Oklahoma
Posts: 2,077
Re: Transmission Identification!

Here's a pic of several
Attached Images
 
sneakysnake is offline   Reply With Quote
Reply

Bookmarks

Tags
identification, tranny, transmission


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:56 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com