![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Check The Champ, Demonstrator
![]() Join Date: Jun 2009
Location: Montreal,Quebec
Posts: 6,627
|
1963 L60 10 lug , want 22.5" wheels
Anyone have a set of 22.5" x 6.00 or 6.75 wheels.
10 on 8.75 with 6.25 centerbore. 1960-1987 GM trucks C50 or C60 schoolbus later RV'S.
__________________
1963 Chevrolet Truck Literature LINK: https://picasaweb.google.com/113840717762774560215 YouTube Channel with 20+ Original Chevrolet Truck Salesmen, Mechanics & Service Department Training Slideshows. https://www.youtube.com/results?sear...otruk63&page=1 |
![]() |
![]() |
![]() |
#2 |
Moderator
![]() Join Date: Aug 2017
Location: Cabarrus
Posts: 417
|
Re: 1963 L60 10 lug , want 22.5" wheels
You and everyone else in North America with these trucks are looking for those wheels. Few and far in-between nowadays. I looked for 3 years and still only managed to get a set of 4 original wheels. Had to order 2 reproduction wheels from Wheels Now. That's who I would contact.
__________________
Alex 1967 C50 292ci Lumber truck 1967 C50 292ci Dump truck 1967 C60 366ci Fire truck |
![]() |
![]() |
![]() |
#3 |
Senior Member
![]() Join Date: Jul 2012
Location: Harrisville, New York
Posts: 459
|
Re: 1963 L60 10 lug , want 22.5" wheels
Same.
I only ended up finding two and ended up just getting the ones from wheels now.
__________________
1960 GMC K1500 LB Fleet Side 1962 GMC K1000 LB Step Side 1988 Chevrolet C2500 |
![]() |
![]() |
![]() |
#4 |
Moderator
![]() Join Date: Aug 2017
Location: Cabarrus
Posts: 417
|
Re: 1963 L60 10 lug , want 22.5" wheels
Were the wheel studs on the rear axle too short with the aftermarket wheels? I've read about some guys running into issues due to the aftermarket wheels being thicker than originals. I used 1 original and 1 aftermarket on my rear end and the stud is flush with the lugnut.
__________________
Alex 1967 C50 292ci Lumber truck 1967 C50 292ci Dump truck 1967 C60 366ci Fire truck |
![]() |
![]() |
![]() |
#5 |
Senior Member
![]() Join Date: Jul 2012
Location: Harrisville, New York
Posts: 459
|
Re: 1963 L60 10 lug , want 22.5" wheels
I did run into the stud issue but only by a thread.
I keep an eye on them and have considered a shallower modern nut with the washer built in. I don't run mine a lot but so far, no issues.
__________________
1960 GMC K1500 LB Fleet Side 1962 GMC K1000 LB Step Side 1988 Chevrolet C2500 |
![]() |
![]() |
![]() |
Bookmarks |
|
|