Wiper Squirter Tubing - Where it Goes? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**KyleSeal** · 10-07-2015, 10:25 PM

Tearing down my 70 I found that my wiper motor has a couple tubes coming off it that are sliced from the last owner, and a grommet on the firewall that has three holes in it, looks factory I'd say considering Brothers sells one exactly like it.

My question - can someone on here show me some pictures and give some insight on how to make this stock again? I'd like to have it working and set up properly just incase I need it. Thanks.

Vehicle: 1970 Chevrolet C/10 (if that even matters)

Kyle.

10-07-2015, 10:25 PM	#1
KyleSeal Senior Member Join Date: Mar 2014 Location: Toano, VA Posts: 882	Wiper Squirter Tubing - Where it Goes? Tearing down my 70 I found that my wiper motor has a couple tubes coming off it that are sliced from the last owner, and a grommet on the firewall that has three holes in it, looks factory I'd say considering Brothers sells one exactly like it. My question - can someone on here show me some pictures and give some insight on how to make this stock again? I'd like to have it working and set up properly just incase I need it. Thanks. Vehicle: 1970 Chevrolet C/10 (if that even matters) Kyle. __________________ "Sometimes I do serve as a good bad example. Glad to be of service." My Build Thread (1967 C10, lowered, EFI, daily truck): http://67-72chevytrucks.com/vboard/s...d.php?t=830809



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.