|
02-15-2017, 09:41 PM
|
#1 |
|
Registered User
Join Date: Jan 2007
Location: near Fresno, Ca
Posts: 31
|
3100 6 year project
Been working on my 1948 Chevy 3100 5.3/L60E conversion for 6 years. Finally started to put a few miles on the truck to sort out the bugs. I have had the Pickup since 1980. Drove it stock till the original 216 froze up in 2006. In 2010 I purchased a 7,000 mile wrecked 09 Chevy 4 door Pickup. I pulled engine, trans and every wire in that vehicle. To date I have done every thing except modify the ecm. I am using the original frame, TCI Mustang style front suspension, Ford 8.8/3:55 post disc brake rear end on modified original leaf springs, Mustang 20 gallon gas tank with fender filler. Tanks kit for intank Walbro fuel pump, Classic gauges and late Chevy Van steering column. I am old school, I want the truck lowered some with a bit of a rake, as well as steel wheels, 14 inch front, 15 inch rear.
|
|
|
|
02-15-2017, 09:48 PM
|
#2 |
|
Post Whore
  
Join Date: May 2015
Location: Alabama
Posts: 14,605
|
Re: 3100 6 year project
Looking good..I recommend you put it on a dyno to get your tune set...well worth the money..
|
|
|
|
|
02-15-2017, 10:10 PM
|
#3 |
|
Registered User
Join Date: Jun 2014
Location: Orlando, Fl
Posts: 36
|
Re: 3100 6 year project
Good Looking Project! Please share some more photos. If you have any questions on the ls swap this board is a wealth of knowledge.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
