Pulled my Cam for Fuel Pump Push Rod - The 1947 - Present Chevrolet & GMC Truck Message Board Network

MobbinINmy69 · 11-20-2013, 04:59 PM

Before everyone says "search it, there are already a lot of threads on this." I've done it. My push rod was jammed, and the bolt on the block for holding it was out. I tried needle nose pliers, i tried small vice grips, i tried to get a thread die up there and the space was too tight, tried to mcgyver an extension to it and nothing. That beezy is stuck. I pulled my cam out and there's MAYBE an eighth of an inch worth of rod sticking out on the cam side. I tried pushing it out with my hand but that thing won't budge at all. Does anyone have any ideas or advice?

11-20-2013, 04:59 PM	#1
MobbinINmy69 Registered User Join Date: Oct 2009 Location: Tacoma, Wa Posts: 24	Pulled my Cam for Fuel Pump Push Rod Before everyone says "search it, there are already a lot of threads on this." I've done it. My push rod was jammed, and the bolt on the block for holding it was out. I tried needle nose pliers, i tried small vice grips, i tried to get a thread die up there and the space was too tight, tried to mcgyver an extension to it and nothing. That beezy is stuck. I pulled my cam out and there's MAYBE an eighth of an inch worth of rod sticking out on the cam side. I tried pushing it out with my hand but that thing won't budge at all. Does anyone have any ideas or advice? __________________ '69 Chevy Stepside 350sbc 4speed automatic 2wd ~There is nothing wrong with America that the faith, love of freedom, intelligence and energy of her citizens cannot cure. ~ Dwight D. Eisenhower Last edited by MobbinINmy69; 11-20-2013 at 05:09 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.