|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-13-2011, 10:49 AM
|
#1 |
|
Registered User
Join Date: Apr 2009
Location: Bowie, Maryland
Posts: 80
|
Shortening a Drive Shaft Question
Hey Board,
Anybody got tips on measuring to shorten a driveshaft? I'm swapping out a Saginaw 3-speed manual tranny for a 700R4. I think the old yoke is good, b/c both old and new are 27-spline, but how should I measure? from what point on the tranny tail to where on the shaft? Any comment, expert or anecdotal would be appreciated. DTT PS This is the O's year! 
__________________
broke d!@k dog Garage 1969 C20 - Project: "Big Sexy" [http://67-72chevytrucks.com/vboard/s...d.php?t=454894] 2003 'Burban - [Big Pop's daily driver] 1969 350/350 Stingray - [as soon as the economy turns...] 1939 Chevy Roadster Pick Up - Project: "Pre-School" (searching now) |
|
|
|
03-13-2011, 11:01 AM
|
#2 |
|
Registered User
Join Date: Nov 2009
Location: Dahlonega Ga.
Posts: 137
|
Re: Shortening a Drive Shaft Question
http://www.dennysdriveshaft.com/Good information at this site. You are going to have a driveshaft shop do this right?
|
|
|
|
|
03-13-2011, 02:06 PM
|
#3 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Shortening a Drive Shaft Question
if having shop doing it talk to them and see what they require in measurement so you"re both on the same page when the shaft is done
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
