![]() |
![]() |
#1 |
Barrito Loco Diablo
Join Date: May 2008
Location: Cherry Valley, Illinois
Posts: 636
|
Lowering question???
Over the next X amount of months, i will be lowering the 2500. I'm shooting for a pretty low stance (probably around 5-6 front, 6-8 rear).
Should i be worried about anything else needed when lowering? Such as drive shaft angles and speedo's? |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,939
|
Re: Lowering question???
2pc driveshafts generally have less issues w/lowering as long as the carrier bearing mount is positioned properly (spaced if necessary). The speedo is only effected by lowering if/when you change tire sizes.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
![]() |
![]() |
![]() |
#3 |
Barrito Loco Diablo
Join Date: May 2008
Location: Cherry Valley, Illinois
Posts: 636
|
Re: Lowering question???
the speedo, i can live without untill working that issue out, as it's currently not functioning anyways... lol. The carrier bearing i guess we'll see how everything plays out, if that's the lot of things to worry about, other than the obvious issues that pop up while working on it. That's not too bad. I was dreading having to change out gears or something like that. thanx.
|
![]() |
![]() |
![]() |
Bookmarks |
|
|