|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-24-2010, 12:35 PM
|
#1 |
|
Registered User
Join Date: Oct 2008
Location: Birmingham, AL
Posts: 123
|
I6 Head/Header question
Check out this pic, where it's circled, there's a stud...will this come out so that I can put a threaded stud in to hold that part of the header on? I have one of the old washers everywhere except the ends, which is where these little studs are, but they aren't threaded (at least on the outside)...this just seems like it would leak if I don't have a bolt holding it down.
Thanks! 
|
|
|
| Bookmarks |
|
|
Threaded Mode