|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-23-2023, 01:38 PM
|
#1 |
|
Senior Member
 
Join Date: Jul 2000
Location: North Texas
Posts: 3,568
|
Mallory dual point distributor #2548201
For you points guys, I have an old Mallory dual point distributor that I picked up at a swap meet 10-12 years ago. I had planned to use it on a 327 back then, but never did.
Fits SBC and BBC The points, cap, and rotor look good, but I'd probably replace the condenser, just because it's old. The shaft spins smoothly with .020" end play, and no lateral play. Parts are still available! $50 + actual shipping cost.
__________________
Mike 1969 C10 LWB -- owned for 35 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes. 1982 C10 SWB -- sold 1981 C10 Silverado LWB -- sold, but wish I still had it! 1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming. Retired as a factory automation products salesman. Worked part-time over the years for an engine builder and a classic car repair shop. Member here for 24 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then! Last edited by MikeB; 04-23-2023 at 01:48 PM. |
|
|
|
| Bookmarks |
| Tags |
| chev, distributor, dual point, mallory |
|
|
Linear Mode
