The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 06-05-2015, 11:09 AM   #1
krmill23
Registered User
 
Join Date: Jun 2015
Location: Meadowlands, MN
Posts: 6
Question My dimmer switch dims my tail lights?

I just bought a '67 C10 for just a few hundred dollars. It ran and drove, but it is very very rusty. For now my main goal is just getting it legal to drive to use just for utility. I have everything done except for the rear lights now.

I discovered this strange problem yesterday. When I turn the dimmer switch all the way up until it clicks, the tail lights go off. The farther I turn the dimmer switch down, the brighter the tail lights get. They just stay on too, no difference when I hit the brake. Any idea what this could be?

I also noticed that the left-rear tail light was much dimmer, and flashed alternatively to the right rear when I put the hazards on, so I took the left-rear tail light apart and discovered the yellow wire had pulled out of the "bulb connector" (not sure what it's called). I cut the wires and have that little part here now, but see no way to solder a new wire into there, it's like an inch long with two small holes going deep in there. I don't see any way to take it apart. Do they sell a part like this where it's already done with just short wires coming out so I can connect it up again real fast? I found the entire rear set on the American Autowire website for $100 after shipping, but I don't think I need to replace all of them. I'd rather just fix this part first.

Anyways, I think that's about the extent of my problems. I just installed a new alternator and universal ignition (the guy I bought it from didn't get it with keys so he hot wired it). Also did a few other things that have nothing to do with the electrical system so I won't mention them here.

Any help would be greatly appreciated!
krmill23 is offline   Reply With Quote
Old 06-05-2015, 02:34 PM   #2
cdowns
Senior Member
 
cdowns's Avatar
 
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
Re: My dimmer switch dims my tail lights?

LOCAL AUYTOPArts store help section with electrical COMPONENTS STOP BY AND FAMILIZE YOURSELF WITH WHATS AVAILABLE FOR NOW AND FOR THE FUTURE YOU'LL SAVE YOURSELF MONEY AND TIME TOO
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane

MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF

DONT BELIEVE EVERYTHING YOU THINK

TAKE MY ADVISE;I DON'T USE IT ANYWAY
cdowns is offline   Reply With Quote
Old 06-05-2015, 03:48 PM   #3
krmill23
Registered User
 
Join Date: Jun 2015
Location: Meadowlands, MN
Posts: 6
Thumbs up Re: My dimmer switch dims my tail lights?

Quote:
Originally Posted by cdowns View Post
LOCAL AUYTOPArts store help section with electrical COMPONENTS STOP BY AND FAMILIZE YOURSELF WITH WHATS AVAILABLE FOR NOW AND FOR THE FUTURE YOU'LL SAVE YOURSELF MONEY AND TIME TOO
Thanks for the reply cdowns! Yeah I suppose it could be anything for the tail light, and not the actual part that is supposed to go in there, if I'm not going to completely restore it or anything. I'll go get a universal tail light attachment and a tail light that will work.

That leaves the dimmer switch problem. Any idea what's going on there?
krmill23 is offline   Reply With Quote
Old 06-05-2015, 03:49 PM   #4
67 chevelle
Registered User
 
67 chevelle's Avatar
 
Join Date: May 2013
Location: WEST PALM FLORIDA
Posts: 1,174
Re: My dimmer switch dims my tail lights?

Old and rusty = grounding issues , my 67 is fairly pristine as far as rust ,,,but,,, I had similar issues with the taillights , mostly because of bad grounding wires
__________________
68 Long Fleet , ly6 , turbo 350 , 3-5 drop , original paint , front discs
67 Small window , 7 foot bed , tweaked 6.0 LSX 2004R Medium Olive
58 Apache fleet , 235 , offy intake , dual exhaust , 4 on the floor , red/white
69 Long Fleet , Custom , 6.0, 4l60 , AC , Medium Olive
67 chevelle is offline   Reply With Quote
Old 06-05-2015, 03:55 PM   #5
krmill23
Registered User
 
Join Date: Jun 2015
Location: Meadowlands, MN
Posts: 6
Re: My dimmer switch dims my tail lights?

Quote:
Originally Posted by 67 chevelle View Post
Old and rusty = grounding issues , my 67 is fairly pristine as far as rust ,,,but,,, I had similar issues with the taillights , mostly because of bad grounding wires

Yeah I figured there were going to be some bad grounds, but it just seemed really strange to me that it would cause a problem with the dimmer switch controlling the tail lights. I'll take a look thanks.

Any other input or ideas would be greatly appreciated as well. Thanks guys!
krmill23 is offline   Reply With Quote
Old 06-05-2015, 04:09 PM   #6
Jonlopes
Registered User
 
Join Date: Mar 2013
Location: Anaheim Hills, CA
Posts: 323
Re: My dimmer switch dims my tail lights?

The dimmer in the headlight switch is for the brightness level of the dash lights and I think the click at the end of the turn is to control the interior cab light while the doors are closed. I think there may be a incorrectly routed wire or a short in your harness.
__________________
1971 Cheyenne Big Block Longhorn
Jonlopes is offline   Reply With Quote
Old 06-05-2015, 05:01 PM   #7
67 chevelle
Registered User
 
67 chevelle's Avatar
 
Join Date: May 2013
Location: WEST PALM FLORIDA
Posts: 1,174
Quote:
Originally Posted by krmill23 View Post
I just bought a '67 C10 for just a few hundred dollars. It ran and drove, but it is very very rusty. For now my main goal is just getting it legal to drive to use just for utility. I have everything done except for the rear lights now.

I discovered this strange problem yesterday. When I turn the dimmer switch all the way up until it clicks, the tail lights go off. The farther I turn the dimmer switch down, the brighter the tail lights get. They just stay on too, no difference when I hit the brake. Any idea what this could be?

I also noticed that the left-rear tail light was much dimmer, and flashed alternatively to the right rear when I put the hazards on, so I took the left-rear tail light apart and discovered the yellow wire had pulled out of the "bulb connector" (not sure what it's called). I cut the wires and have that little part here now, but see no way to solder a new wire into there, it's like an inch long with two small holes going deep in there. I don't see any way to take it apart. Do they sell a part like this where it's already done with just short wires coming out so I can connect it up again real fast? I found the entire rear set on the American Autowire website for $100 after shipping, but I don't think I need to replace all of them. I'd rather just fix this part first.

Anyways, I think that's about the extent of my problems. I just installed a new alternator and universal ignition (the guy I bought it from didn't get it with keys so he hot wired it). Also did a few other things that have nothing to do with the electrical system so I won't mention them here.

Any help would be greatly appreciated!
If you have a wooden bed there is a grind wire from the drivers side frame to the metal under the tailgate Make sure that's good
Posted via Mobile Device
67 chevelle is offline   Reply With Quote
Old 06-05-2015, 05:05 PM   #8
krmill23
Registered User
 
Join Date: Jun 2015
Location: Meadowlands, MN
Posts: 6
Re: My dimmer switch dims my tail lights?

Quote:
Originally Posted by Jonlopes View Post
The dimmer in the headlight switch is for the brightness level of the dash lights and I think the click at the end of the turn is to control the interior cab light while the doors are closed. I think there may be a incorrectly routed wire or a short in your harness.
Yeah this seems to make more sense to me, although I really hope it's just a bad ground.
krmill23 is offline   Reply With Quote
Old 06-05-2015, 05:06 PM   #9
krmill23
Registered User
 
Join Date: Jun 2015
Location: Meadowlands, MN
Posts: 6
Re: My dimmer switch dims my tail lights?

Quote:
Originally Posted by 67 chevelle View Post
If you have a wooden bed there is a grind wire from the drivers side frame to the metal under the tailgate Make sure that's good
Posted via Mobile Device
Nope, metal box. It's really rusty though, I almost put my foot right through it when I was cleaning all the moss and leaves out of it!

I found a nice thread on this site with all the locations of the grounds. I'll make sure those are all good first I suppose.
krmill23 is offline   Reply With Quote
Old 06-26-2015, 06:11 PM   #10
krmill23
Registered User
 
Join Date: Jun 2015
Location: Meadowlands, MN
Posts: 6
Re: My dimmer switch dims my tail lights?

So I made sure I had good grounds and grounded the body to the frame in 4 spots. I found a bunch of melted wires coming from the alternator and running along the front of the truck to the battery and replaced those. The brake lights weren't working but that was just a blown fuse, now they work. But still the dimmer switch controls the tail light dimness, one brighter than the other, and when the headlamp switch is pulled out, the left tail light is so bright there is no difference when I hit the brake.

I'm running out of ideas! Is it possible that this is the headlamp switch? I have the instrument cluster out it would be pretty easy to replace. Thanks for your input!
krmill23 is offline   Reply With Quote
Reply

Bookmarks

Tags
electrical issues, lights, switches, tail lights


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:17 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com