|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-25-2008, 07:00 PM
|
#1 |
|
Registered User
Join Date: Jan 2008
Location: Raleigh, NC
Posts: 321
|
Plug for wire harness?
I'm getting ready to take my cab off the frame but need to remove the 4 wires that run to the back taillights. Does this just unplug from the firewall? It seems as it might but when I pull on it nothing pops out. I didn't want to damage anything so I didn't try too hard.
|
|
|
|
10-25-2008, 07:16 PM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Re: Plug for wire harness?
It just unplugs as you suspected. If you pull on the lip it will help. Also spraying it down with a soapy solution and wiggling it around will loosen it up. There is a male plug on the inside that you should unplug before attempting to pull the outside plug out.
Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
10-25-2008, 07:44 PM
|
#3 |
|
Registered User
Join Date: Jan 2008
Location: Raleigh, NC
Posts: 321
|
Re: Plug for wire harness?
yep, that worked just like you said. Thanks
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
