|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-03-2005, 04:40 PM
|
#1 |
|
Registered User
Join Date: Feb 2005
Location: Lebanon TN
Posts: 14
|
buy or machine front shaft
I have a 79 gmc 3/4 ton and the front shaft has all of the splines ripped off of it. I have been told that these front shafts are hard to find. I am wondering wether it would be easier to have it remachined or try to find one. thanks in advance
|
|
|
|
02-04-2005, 12:13 AM
|
#2 |
|
Registered User
Join Date: Sep 2003
Location: Shelbyville, Indiana
Posts: 614
|
If it were me I would try and find another one or have one made, I was looking for a rear shaft before and Auto zone or Advance told me that they could get the front but not the rear.
__________________
Chuck '85 Chevy Silverado 4X4  '91 Chevy 4X4 Suburban http://www.cardomain.com/memberpage/545941 |
|
|
|
|
02-04-2005, 12:43 AM
|
#3 |
|
california fill
Join Date: Apr 2004
Location: Sunny So-Cal
Posts: 694
|
what do you mean front shaft? is it 4WD? if you're talking about the slip yoke or the front output/input, than definately do not have it re-splined. that will cost a fortune. there is virtually nothing that cant be replaced relatively cheap on these trucks. hard to find, my arse! give me a PM if you need the name and number of a GOOD driveline supply (in so. calif.)
PC |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
