![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Active Member
![]() Join Date: Jan 2011
Location: columbia, SC
Posts: 156
|
72 blazer door jamb measurements
can someone post the correct measurements between the front door jamb and the strike plate. maybe at the top middle and bottom . My floor is completely gone and i am trying to line everything back up.
Posted via Mobile Device Posted via Mobile Device |
![]() |
![]() |
![]() |
#2 |
Registered User
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,438
|
Re: 72 blazer door jamb measurements
I think a better solution would be to hang your doors, and use them as a template. Hang all your sheetmetal to make sure it all lines up. I could give you a demension, but it might not be of any use to you, since my doors could be differant
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
![]() |
![]() |
![]() |
Bookmarks |
|
|