|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
09-02-2010, 01:46 AM
|
#1 |
|
Registered User
Join Date: Jul 2009
Location: MT
Posts: 319
|
Lower Control Arm Bushing Torque?
I am replacing the control arm shafts with new moog ones on my 67 and in my 67 Chassis Service Manual, all it say is "Adjust shaft until it is centered in control arm, then turn bushings in and torque to specifications". But I can't see where is says what these torque specifications are. Does anyone know?
While I am at it, the upper torque specs say 95ft/lb. Does that sound right? This is my first time doing this...
__________________
'67 C-10 Shorty - 454, 5spd, and speed holes! |
|
|
|
09-02-2010, 07:59 AM
|
#2 |
|
Senior Member
Join Date: Jan 2003
Location: daytonabeach
Posts: 22,956
|
Re: Lower Control Arm Bushing Torque?
back of the book all torque specs listed
__________________
71c-10 350/2004r/4:11 lowered3/4 longbed/dead by hurricane MEANING OF DEATH::::: SOMEBODY ELSE GETS YOUR STUFF DONT BELIEVE EVERYTHING YOU THINK TAKE MY ADVISE;I DON'T USE IT ANYWAY |
|
|
|
|
09-02-2010, 09:36 AM
|
#3 |
|
Registered User
Join Date: Jul 2009
Location: MT
Posts: 319
|
Re: Lower Control Arm Bushing Torque?
Duh, thanks!
 One other question. It has "new" torque spec and "replacement" torque spec listed. Which one do I got off of?
__________________
'67 C-10 Shorty - 454, 5spd, and speed holes! |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
