|
01-18-2015, 08:20 PM
|
#1 |
|
Senior Member
 
Join Date: Mar 2014
Location: Toano, VA
Posts: 884
|
Front Drop Springs
I want to install my new 3 inch front drop springs tomorrow as I've installed the rear 5 inch drop ones today, and would like to have suspension out of the way.
Can I remove the front springs with spring compressors, without taking apart the control arms? If so, will compressors be enough? I would like to make this a day job, take olds out put news in and get rolling all in the same day. Is that possible?
__________________
"Sometimes I do serve as a good bad example. Glad to be of service." My Build Thread (1967 C10, lowered, EFI, daily truck): http://67-72chevytrucks.com/vboard/s...d.php?t=830809 |
|
|
|
01-18-2015, 08:29 PM
|
#2 |
|
Registered User
Join Date: Jun 2011
Location: Sunbury, N.C
Posts: 140
|
Re: Front Drop Springs
I popped the uca off and lowered the lower control arm a spindle down and they came right out. Install new spring and jack lca and spindle back up and you are good.
|
|
|
|
|
01-18-2015, 10:51 PM
|
#3 |
|
Registered User
Join Date: Dec 1999
Location: Austin, TX, USA
Posts: 7,724
|
Re: Front Drop Springs
Like he said.
But there is NO way to remove the spring without separating one of the ball joints. With motor in the truck, you shouldn't need compressor to get the stock spring out. And I had no problems putting a 2" lower spring IN without a compressor.
__________________
44 Willys MB 52 M38A1 64 Corvette Coupe 68 Camaro 'vert LT1 & TH700 69 Z/28 355 12.6's @110 69 Chevy Short Step 4 1/2"/7" drop 72 Jimmy 4WD 4spd 4" & 35's 02 GMC 2500HD 4x4 Duramax |
|
|
|
 |
| Bookmarks |
| Tags |
| 1970, drop, lowered, springs |
|
|
Linear Mode
