Tuning options - The 1947 - Present Chevrolet & GMC Truck Message Board Network

crimespree · 07-05-2009, 02:10 PM

i need some suggestions as to what i should do to get the most power out of my motor. this is the set up...

-350 bored to 355
-Crower Cam with around .502 lift (dont know the duration)
-Roller Rockers
-Edelbrock Performer RPM, Dual Plane Intake Manifold
-2" spacer w Holley 650cfm carb on top
-GM HEI ignition with Accel parts(coil, cap, etc.). It had an MSD ignition module, but was dead, and ended up going back to a stock GM ignition module to get it running.
-Headers are 1 5/8" primaries, 3" collector
-Exhaust is full 3" with "H" pipe into Flowmaster 1 chambers

let me know what you think,

07-05-2009, 02:10 PM	#1
crimespree Registered User Join Date: May 2009 Location: Dothan, AL Posts: 94	Tuning options i need some suggestions as to what i should do to get the most power out of my motor. this is the set up... -350 bored to 355 -Crower Cam with around .502 lift (dont know the duration) -Roller Rockers -Edelbrock Performer RPM, Dual Plane Intake Manifold -2" spacer w Holley 650cfm carb on top -GM HEI ignition with Accel parts(coil, cap, etc.). It had an MSD ignition module, but was dead, and ended up going back to a stock GM ignition module to get it running. -Headers are 1 5/8" primaries, 3" collector -Exhaust is full 3" with "H" pipe into Flowmaster 1 chambers let me know what you think,



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.