The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 07-11-2024, 12:09 AM   #1
Dedmunds62
New Member
 
Join Date: Feb 2024
Location: Centerville, Utah
Posts: 13
Engine Id

Purchased a 72 C30 Longhorn, but have conflicting info on the motor that's in it.
Block#s
TO703JA
919Z365441
Numbers in the front passenger side of block.
Any knowledge would be appreciated.

3969864 numbers on the back

Last edited by Dedmunds62; 07-11-2024 at 12:16 AM. Reason: More info
Dedmunds62 is offline   Reply With Quote
Old 07-11-2024, 12:33 AM   #2
RustyPile
Registered User
 
RustyPile's Avatar
 
Join Date: Dec 2017
Location: Elkhart, Texas
Posts: 1,806
Re: Engine Id

According to this site:
http://camaros.org/pdf/LimeBook.pdf
And my accuracy at deciphering, your engine is 1 of 4 possibilities.

1964 283
1965 409
1967 427
1969 396

Built at the Tonowanda engine plant on July 3rd.

Refer to the casting numbers on the back of the blok for the exact date of casting.
RustyPile is offline   Reply With Quote
Old 07-11-2024, 12:40 AM   #3
Dedmunds62
New Member
 
Join Date: Feb 2024
Location: Centerville, Utah
Posts: 13
Re: Engine Id

Thanks, I had it pinned down to a 69 Chevelle 396
But didn't think that seemed right.
Was planning on pulling this out & selling, if this is accurate does it have much value? Seems to be fairly common.
Dedmunds62 is offline   Reply With Quote
Old 07-11-2024, 12:59 AM   #4
RustyPile
Registered User
 
RustyPile's Avatar
 
Join Date: Dec 2017
Location: Elkhart, Texas
Posts: 1,806
Re: Engine Id

Quote:
Originally Posted by Dedmunds62 View Post
Thanks, I had it pinned down to a 69 Chevelle 396
But didn't think that seemed right.
Was planning on pulling this out & selling, if this is accurate does it have much value? Seems to be fairly common.
According to the site, the engine came from a '69 Camaro, 325 HP, 4 bbl carb, and a powerglide transmission.

Correct, 396s are pretty common. Your engine's condition weighs greatly on its value.. It could be anything from a nice boat anchor, to the foundation for a race engine. If your engine runs, leave it in place until you find a buyer.. Let the prospective buyer hear and see it run. Sitting on the garage floor, it's simply a pile of cast iron..

Here's something that might sway your decision to sell. The big block 402s of the era of our trucks was actually a 396 bored .030"...
RustyPile is offline   Reply With Quote
Old 07-11-2024, 12:40 PM   #5
MJN
Registered User
 
MJN's Avatar
 
Join Date: Feb 2000
Location: Maquoketa, Ia/ Orr, Mn
Posts: 3,044
Re: Engine Id

I'd double check your block casting number again, I don't see a 3969864 listed, there is a 3969854 which would be a 400/402 69-72 Chevelle/Camaro or 70 Nova or 70-72 truck. But with the partial VIN stamped it wont be a truck block since VIN stamping truck blocks did not start until '73.
The Lime Book shows the JA stamping for 396/325hp 1969 Chevelle/El Camino backed by a manual trans.
Attached Images
 
__________________
'51 South Bend Model "9A"
'56 Chevy 3600 NAPCO
'74 Chevy Cheyenne Super K20-restored on 37's
'72 GMC Sierra Custom K2500- in progress
'08 GMC Envoy Denali
'12 GMC Sierra 2500HD Denali
'17 GMC Yukon XL
VCCA member #58596
http://www.nohrco.com
MJN is offline   Reply With Quote
Old 07-11-2024, 05:24 PM   #6
RustyPile
Registered User
 
RustyPile's Avatar
 
Join Date: Dec 2017
Location: Elkhart, Texas
Posts: 1,806
Re: Engine Id

Quote:
Originally Posted by MJN View Post
I'd double check your block casting number again, I don't see a 3969864 listed, there is a 3969854 which would be a 400/402 69-72 Chevelle/Camaro or 70 Nova or 70-72 truck. But with the partial VIN stamped it wont be a truck block since VIN stamping truck blocks did not start until '73.
The Lime Book shows the JA stamping for 396/325hp 1969 Chevelle/El Camino backed by a manual trans.
Well, so much for the accuracy of both the sites we're referencing...
RustyPile is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 02:59 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com