|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-20-2007, 12:41 PM
|
#1 |
|
Registered User
Join Date: Jul 2005
Location: austin texas
Posts: 113
|
Re-building Door Hinges
Is it possible to re-build door hinges with just replacing the pin? both of my doors are sagging and im looking for a fix that doesnt involve spending 40$ a peice on new hinges. any suggestions will be a great help, thanks alot.
Travis |
|
|
|
11-20-2007, 12:47 PM
|
#2 |
|
That's right, it's Copper!!
Join Date: May 2007
Location: Bakersfield, Central California
Posts: 558
|
Re: Re-building Door Hinges
The pins with new bushings come in a kit. Very easy to rebuild, I got mine at Early Classic.
|
|
|
|
|
11-20-2007, 04:01 PM
|
#3 |
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: Re-building Door Hinges
Sure, but if they are very bad the steel parts can be worn too. This can still be fixed. A little welding can re-new the hole. Don't try to put the new bushings in an egg shaped hole, it will fail again quickly. It really only becomes a problem when the spring/check mechanism gets rusted and bound up. They will wear a flat spot and stick. It is usually easier to replace them at that point.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
