![]() |
Register or Log In To remove these advertisements. |
|
|
![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Registered User
Join Date: Feb 2010
Location: Hoschton, GA
Posts: 18
|
NEED HELP! 402BB and just seen that flexplate and torque converter dont match up
i have had the whole motor cleaned up and rebuilt and went to bolt up the flexplate and converter and seen that only half the bolts match up. it has the 168 tooth plate and it matches up fine with the starter. what problems could this cause, if any?
__________________
67 chevy 402 BB w/ TH400 Learning as much as i can before i dig in!! |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Aug 2003
Location: Lubbock, Texas
Posts: 2,443
|
Re: NEED HELP! 402BB and just seen that flexplate and torque converter dont match up
How many is that? I think the converter only has three holes that you use.
__________________
72 Cheyenne Super 80 Silverado Blazer 2wd |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Oct 2005
Location: Northern Arkansas
Posts: 1,136
|
Re: NEED HELP! 402BB and just seen that flexplate and torque converter dont match up
Yes, only 3 holes get used but a lot of flexplates are drilled for 2 different patterns. 1 pattern is slightly smaller in diameter.
|
![]() |
![]() |
![]() |
#4 |
Registered User
Join Date: Feb 2010
Location: Hoschton, GA
Posts: 18
|
Re: NEED HELP! 402BB and just seen that flexplate and torque converter dont match up
yea i figured out that it was drilled for 2 patterns.
![]()
__________________
67 chevy 402 BB w/ TH400 Learning as much as i can before i dig in!! |
![]() |
![]() |
![]() |
Bookmarks |
|
|