![]() |
![]() |
#1 |
Registered User
Join Date: Dec 2010
Location: NC
Posts: 666
|
Tilt columns
How hard is it to rebuild an original truck column?
What are the pieces that you would say should ALWAYS be replaced? What should I look for in a good used column (typical problem areas)? |
![]() |
![]() |
![]() |
#3 |
Registered User
Join Date: Mar 2001
Location: Paradise TX USA
Posts: 1,200
|
Re: Tilt columns
It's not that difficult. Just disassemble, clean and inspect all the parts and replace anything that shows excessive wear. (Usually, upper and lower bearings and turn signal switch)
__________________
"Negative people always seem to have a problem for every solution" |
![]() |
![]() |
![]() |
Bookmarks |
|
|