Boyd Welding Side Fill Questions - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**KyleSeal** · 06-04-2017, 09:54 PM

About to give AZ Pro a call to place an order on a Boyd tank. I'm looking to get a side fill and put a gas flap in the side of the bed.

Are these tanks easy to use in the side fill configuration? Does it clear the bottom of the bed (fill neck to bed floor) easily and with wiggle room?

Also, do you have to remove any crossmembers to get the tank to get into spot or does it go into place easily?

Id like to avoid bed fill because if my tailgate on this truck ends up like my 84 I'll hate opening and closing it.

Pics would be very helpful as well as ideas.

Thanks in advance.

06-04-2017, 09:54 PM	#1
KyleSeal Senior Member Join Date: Mar 2014 Location: Toano, VA Posts: 882	Boyd Welding Side Fill Questions About to give AZ Pro a call to place an order on a Boyd tank. I'm looking to get a side fill and put a gas flap in the side of the bed. Are these tanks easy to use in the side fill configuration? Does it clear the bottom of the bed (fill neck to bed floor) easily and with wiggle room? Also, do you have to remove any crossmembers to get the tank to get into spot or does it go into place easily? Id like to avoid bed fill because if my tailgate on this truck ends up like my 84 I'll hate opening and closing it. Pics would be very helpful as well as ideas. Thanks in advance. __________________ "Sometimes I do serve as a good bad example. Glad to be of service." My Build Thread (1967 C10, lowered, EFI, daily truck): http://67-72chevytrucks.com/vboard/s...d.php?t=830809



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.