|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-24-2002, 05:55 PM
|
#1 |
|
Registered User
Join Date: Jan 2002
Location: Calgary, Alberta, Canada
Posts: 451
|
Tranny fluid level check
Dumb Question. I am getting ready to hit the road this summer (snow almost off the streets), and thought now that I have tuned every thing, I would go thru all hoses, connections , fluids, ect. to make sure everything is ready.
Got to the tranny fluid, and had a brain fart. I know that I have to check the tranny fluid level with the engine running and warm, and at idle, but will this make the tranny hot enough to check, or do I actually have to drive the truck a few miles to get the tranny hot enough? It looks down a quart, but I have only been idling in garage, is this hot enough for checking level? Don't want to over fill tranny.
__________________
72 C10 Cheyenne Super Full trim Factory tach dash A/C dash Factory tilt 350 / 350 power train - with Edelbrock components. |
|
|
|
03-24-2002, 06:03 PM
|
#2 |
|
its all about the +6 inches
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,693
|
Operating temp...go around the block a few times and gun it a couple times.
Also, right before you pull the dip stick, go through all the gear selections, pausing at every one, then back up through, pausing again. This will fill the valve body copletly and give the best reading. ------------------ '69 G.M.C. 350/350. Trying to clean up the left over damage from the Dope-Smokin-Old-Man I've been dubbed the Longhorn Freak/Fanatic/Expert, I just hope I can live up to it. Need to pick up the one ton Longhorn with a PONTIAC 350/350soon. Thanks every one!  Check out The Longhorn Webite. If you need a pic posted, E-mail me at longhornmail@yahoo.com Andy, in Columbus Ohio |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
