![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Revitalizing a 6T C10
![]() Join Date: Aug 2017
Location: Santa Barbara, CA
Posts: 210
|
Buddy Bucket TearDown / Assembly?
This may not be the correct spot, but I figured id start with the most knowledgeable group, as the only upholstery section I could find was the FAQ...
I have what I believe to be an original (67/68) set of buddy buckets ( I know they weren't offered factory in 60-65) in my 1960 truck. ![]() I have a broken and stripped stud / bolt that holds the seat to the frame : ![]() and I was wondering if anybody has any insight into the best way to tackle these. I see that I can adjust the sliders to be able to unbolt from the individual seat frames : ![]() but I'm not sure how to tackle this stud, and the removal, and if I should do all of them at the same time? Are these square headed / swaged into the hole? There are also some of what I assume were gliders or something - ![]() ![]() does anybody reproduce these? and finally, does anybody have any insight into if this "spacer" is stock and if its supposed to be held in / on by anything? ![]()
__________________
1960 C-10 Apache- "Rusty the Redneck Reject"
1/2 Ton short bed step side. 350 crate motor, 3 speed manual (floor shifted) MKII - Buddy Buckets and Glass Packs 20+ year long term project in process Lots of Rust, more memories... |
![]() |
![]() |
Bookmarks |
Tags |
buddy, buddy bucket, interior, seat |
|
|