|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
02-22-2003, 02:45 PM
|
#1 |
|
Dreaminator
Join Date: Feb 2003
Location: Broken Arrow, Oklahoma
Posts: 156
|
Anybody running Gear Vendors OD with TH400?
I am kind of (yes they are expensive) considering adding a Gear Vendor OD to present TH400. Several questions. One, I assume a single shortened drive shaft. Anybody not go to a single shaft? Is it possible? Two, what rearend ratio did you go with? Anybody running the setup with less than a 3.73? Three, if you run a TH400/GV did you mount the shifter on the column, dash, or floor? Thanks.
__________________
The Dreaminator Daily Driver 1971 Cheyenne 10 Lwb Tilt/Tac 402 .030 TH400. |
|
|
|
| Bookmarks |
|
|
Linear Mode
