|
05-01-2002, 10:53 PM
|
#1 |
|
Registered User
Join Date: May 2002
Location: folsom, ca, usa
Posts: 1
|
Transmission help!
I have a 1970 GMC shortbed that I bought new, had a three speed in it and I changed out to a saginaw 4 speed. I also still have the two piece driveshaft. I am not pleased with the saginaw and would like to go to a muncie 4-speed: questions
Which Muncie will fit, the length is 21.5 inches. Which input and output spline do I have (10-27?) Anyone have any preferences on Muncies? m-20, 21 or 22? Also I have no transmission crossmember, didn't have with 3 spd, or with saginaw 4 spd, would I need one with the Muncie? I would certainly appreciate any suggestions. |
|
|
|
05-02-2002, 05:47 AM
|
#2 |
|
Careful, they attack...
Join Date: Aug 2001
Location: Waterford, MI, USA
Posts: 1,107
|
What don't you like about the saginaw? A muncie is just a WAY more $$$$ Saginaw. To answer your questions, all Saginaws had a 10 spline input, the output yopu have is the smae as a th 350. If you get a Muncie it will either have the big or small output, you'll notice when you see it. You won't need a trans x-member. It will just slide in where your saginaw was. You will need a different shifter mount, but those are easy to come by. You won't need a new bell either, all standard trnasmissions of that era had the same bolt pattern to the bell. Good luck.
------------------ 69 swb - in the process of being torn down and born again! |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
