|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-15-2022, 04:57 PM
|
#1 |
|
Registered User
Join Date: Feb 2022
Location: CENTRAL OKLAHOMA
Posts: 23
|
Upper control arm washers
1982 ½ ton C10
I am upgrading my 70 c10 to power steering using a 1982 doner. Ran into a problem on my suspension rebuild, 2 leftover washers in my bucket (small ones in the pic). I figured out where they go. 1 washer per upper control arm next to the rear bushing. Circled in red in the pic. The picture is a lot better on my computer, I can see them clearly. It bugs me I left them out, but they don’t appear to be needed. I can’t find them in the catalogs. I have not found a thread here of anybody using them in their rebuild, no you tube videos either. So……..can I leave them out?
__________________
David |
|
|
|
06-20-2022, 11:31 AM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,068
|
Re: Upper control arm washers
I doubt there will be significant impact. I'd roll w/o them.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
