The 1947 - Present Chevrolet & GMC Truck Message Board Network

Page 2 of 2

Show 40 post(s) from this thread on one page

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)

- The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)

- - Just finished, 9:00PM (https://67-72chevytrucks.com/vboard/showthread.php?t=240740)

Rc 415

05-14-2007 08:27 PM

Re: Just finished, 9:00PM

Quote:

Originally Posted by jdmaffeo (Post 2173840)

I used the same flip kit and c-notches from GMC Pauls. I cut off the u-bolts but left about an inch sticking down. Here is how it looks with them cut. I agree that they were way too long before!

That looks pretty nice! I think I may just have to keep the new u bolts and use the old ones though, because I like a lower drop, I'll just get blocks and use the new u bolts at that time.

Ivan D.

05-15-2007 12:14 AM

Re: Just finished, 9:00PM

Personally I'd tighten them U-bolts up, measure 1/2" from the face of the nuts, and cut there - then again I've got a damn good reason to be so wary of ground clearance and stuff potentially being caught, I had a cruise control incident last fall and I lost my side exhaust and two good rear tires cause stuff got caught on a curb...

Hoods69BadBowTie

05-15-2007 01:10 AM

Re: Just finished, 9:00PM

Damn, looks great. Awesome job!

All times are GMT -4. The time now is 01:44 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page