Re: Suburban rear half part out/cuts
 

I took two screenshots from posts 15 & 16. If you need both sides ill do my quotes $20 each for the cuts, I’ll ship them free if you don’t mind them being 11.5”x11.5” cuts. So it would be $40 shipped for the pair

Re: Suburban rear half part out/cuts
 

Payment sent

Re: Suburban rear half part out/cuts
 

Got it, This is you. Not exactly 11.5x11.5 but plenty for what you’ll be doing.

Re: Suburban rear half part out/cuts
 

Still have a lot of the pieces

Re: Suburban rear half part out/cuts
 

Hello, interested in the entire tailgate. Its a bit of a drive for me from here, but Im trying to swing a 1 ton deal for the ride home and wouldnt be too bad then. Ill keep you posted how it works out or if it will at all.

Re: Suburban rear half part out/cuts
 

Aight then

Re: Suburban rear half part out/cuts
 

Ok, sorry on the wait. Other plan didnt work out. Im planning on going to the squarebody show in Dawsonville Aug 10. Would like to meet up with you that morning then go to the show. Ill pm my number and you can call or message if that will work for you.

Re: Suburban rear half part out/cuts
 

Gate picked up by Waylon and some shooting the **** for free.

Re: Suburban rear half part out/cuts
 

Yes sir, thanks. I was going to mention that here and bring this back to the top. Good talking with you and good luck on the crew-wagon, nice combo of parts on your build.

Re: Suburban rear half part out/cuts
 

Not much left but if you need something I’ll slash prices to move it

Re: Suburban rear half part out/cuts
 

TtT

Re: Suburban rear half part out/cuts
 

I didn't see it, but curious if you have the driver's wheel well? I need the front flange off it so I can patch it onto my passenger rear wheel well where the spare would normally go.

Re: Suburban rear half part out/cuts
 

I just went outside and looked, it is eat up. Unless you can make the flange that goes between the tubs work I don’t have anything to help

Re: Suburban rear half part out/cuts
 

I'm guessing you're talking about the section of the tub that runs front to back? I need a piece that will go here. Its about 2" tall and 11" wide. What do you think?

Attachment 1949760

Re: Suburban rear half part out/cuts
 

You are correct on the front to back piece. If you compare to your tub in the picture and looks like the front to back section will work. I’ll remove the wood and check the condition on the tub I have

Re: Suburban rear half part out/cuts
 

It’s an old thread with old parts, but still have them stashed behind the house.

Re: Suburban rear half part out/cuts
 

For mrweld. What’s left

Re: Suburban rear half part out/cuts
 

those will work fine, just need the sheet metal if you need the rest

Re: Suburban rear half part out/cuts
 

So if I finished the vertical cut to the top so they are a lot smaller to ship would that work? Say $20 a side plus $20 for shipping & PayPal’s fee, $60 all in to your door? If so just use my paypal below and I’ll get them cut when I wake up this afternoon.

Re: Suburban rear half part out/cuts
 

I have a big rust hole in top, I will need them as pictured. I think that will cover it

Re: Suburban rear half part out/cuts
 

I’ll do some weights and measuring later then

Re: Suburban rear half part out/cuts
 

ok thanks

Re: Suburban rear half part out/cuts
 

These are gone. Few pieces left if anyone could use something make an offer