GA Suburban rear half part out/cuts

[Madkidd007]

Do not private message me before inquiring in the thread.

Everything from the rear of the back doors is up for grabs. Rusted parts cut off and thrown out. As of right now I can ship out USPS on a daily basis, Bigger items are more difficult and may take a few days due to my work schedule. All rust or dents will be shown and circled. If you only need part of an item let me know and we’ll see if we can make a deal. Possible barter/trade for body parts that will help with my build

1
Rear hatch style sill plate, pinholes in center where barn doors would latch, seen better and worse but still intact and useable $60

[Madkidd007]

2
Passenger side lower window frame
$60

[Madkidd007]

3
Upper rear sill hatch style
$50

[Madkidd007]

Scrapped

[Madkidd007]

Scrapped


5
Driver side rear lower window frame
$50

[Madkidd007]

Scrapped


6
Passenger side tailgate latch/lower d-pillar
$60 With hardware
$35 Without hardware
$25 Hardware only, support bolt & latch receiver plate

[Madkidd007]

Scrapped


7
Upper 1/2 D-pillar
$25

[Madkidd007]

8
Jack mounting bracket
$25

[Madkidd007]

9
Rear driver side upper window frame
$50

[Madkidd007]

Scrapped

10
Passenger rear wheel well
$50

[Madkidd007]

11
Passenger rear trim panel bracket
$15

[Madkidd007]

Scrapped

[Madkidd007]

Scrapped

[Madkidd007]

Scrapped

[Madkidd007]

Sold!!!

15
Drivers taillight corner
$70 as pictured
$50 without hardware
$25 Hardware only, support bolt & latch receiver plate
$20 12”x12” cuts
$15 tail or reverse buckets

[Madkidd007]

Sold!!!

16
Passenger tail panel
$50 as pictured
$20 12”x12” cuts
$15 taillight bucket
$10 reverse bucket not in too good of shape, fell off

[Madkidd007]

Rust as show. In the upper middle sill area
D-pillar, roof area, and inner roof structure solid

$150 as is
$80 cut down the middle
$70 each corner trimmed to ship
Corners look like I could trim 1.5” in both directions and they would fit in a large flat rate box

[Madkidd007]

Additional

[Madkidd007]

Sold entire gate

Functioning eat up tailgate, key turns and locks/unlocks
$100 as pictured including key
$50 without any hardware
$75 for all hardware(latches,linkage,supports, push button w/ key, anything that unbolts)
$15 cuts up to 12”x12”
$20 for cut around push button
$55 cut with push button including key
$75 for anything that’ll fit in a large flat rate or message board flat rate(including the key with push button)

[Madkidd007]

Sold

Upper hatch
$75 as pictured
$20 handle
$15-$20 up to 12”x12” cuts
$50 shipped for anything that’ll fit in a large flate rate, including cuts and I’ll scrap the rest.

[Madkidd007]

Yay last one

[Madkidd007]

Rear side glass
$50 for the pair

[Madkidd007]

Additional hatch and handle pictures. Handle is pretty rough

[Madkidd007]

If you need more than one item I’ll make bundle discounts

[Madkidd007]

Open to offers, don’t wanna scrap something that someone could use