The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1988 - 1998 GMT400 Chevy & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=12)
-   -   '99 Tahoe Keyless remote programing (https://67-72chevytrucks.com/vboard/showthread.php?t=109083)

87 STEPPER 06-22-2004 11:05 PM

'99 Tahoe Keyless remote programing
 
Any one know or have the procedure for doing this i just won a spare remote on ebay but need to reprogram it for my truck.

Tnkx.

Old Dave 06-23-2004 08:47 AM

I found this on another site:http://www.automotiveforums.com/vbul...d.php?t=162483

99-2door 06-23-2004 01:26 PM

From that post, this is the procedure you need.


Originally posted in another thread by "GMMERLIN" instructions on programming a 99 suburban-----
When reprogramming the remote control door lock reciever, All transmitters must be programmed at this time in order for the transmitters to operate the vehicle. Transmitters not programed at this time will not work and the procedure will have to be redone with all the transmitters.

Ground pin 4 to pin 8 of the data link connector (DLC). The receiver will respond by locking and unlocking the doors, and activating the liftgate window release (if equipped) within 2 seconds.
Press and hold the LOCK and UNLOCK buttons simultaneously on the first transmitter to be programmed until the locks cycle (approximately 10 seconds).
Repeat step 2 for up to four total transmitters to be programmed (if available). The receiver will respond by locking and unlocking the doors and activating the liftgate window release (if equipped) within 2 seconds.
Remove the ground applied to the DLC.
Lock and unlock the doors in order to verify the transmitter operation.
Activate the rear window release in order to verify the transmitter operation.

Old Dave 06-23-2004 02:22 PM

Thanks 99 2-door...not too good on cutting & pasting yet. Hope this works for him. :)

87 STEPPER 06-23-2004 07:19 PM

Hey thanks alot guys i'll giver a try when i receive the new remote.

87 STEPPER 06-29-2004 06:21 PM

Well today i tried that procedure out and it worked perfectly now i have a good spare.

Thanks Old Dave and 99-2door.


All times are GMT -4. The time now is 07:36 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com