The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1967 - 1972 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=3)
-   -   Leaking water pump (https://67-72chevytrucks.com/vboard/showthread.php?t=109166)

dubie 06-23-2004 04:33 PM

Leaking water pump
 
If a water pump were to start leakin, where excatly does it leak from? The reason I ask is I have been blaming this dripping of antifreeze from the lower rad hose on the hose, but i stuck my hand up farther in behind the pulley and it's wet up there. Does anyone have a pic of where this would leak from??

krue 06-23-2004 04:43 PM

If I remember correctly there is a weep hole on the bottom of the waterpump housing, if the seal around the shaft for the pump is leaking, that is where it will come out.

SideStepper 06-23-2004 04:56 PM

No picture, but the common spots to check for water pump leaks would be:

1. Gasket at engine block.
(Replace gasket/sealer)

2. Bolt holes into engine block
(Just remove bolt, not pump..... & use sealer on bolt & reinstall)

3. "Weep hole" in pump housing, located bottom side, underneath shaft.
(no fix, replacement water pump required)

Hope this helps, Good luck!

flip66 06-23-2004 06:08 PM

they are right your weep hole is leaking get you a mirror and look at the bottom of the pump and you will see it. It will be a very slow leak and run down the lower hose.

68 Stepside 06-23-2004 07:29 PM

2 Attachment(s)
Tim, here's a few pics, they're kinda hard to see, but you'll get an idea of where the weep hole is.

smitty62 06-23-2004 07:53 PM

Better get it off.......once they start leaking at the weep hole the bearing goes out in a hurry! :(

Gee_Emm 06-23-2004 10:10 PM

Looks like someone is pissed off at their waterpump :p

http://67-72chevytrucks.com/vboard/a...id=86000&stc=1

walker 06-24-2004 12:29 AM

Had an s-10, same basic water pump, it started to leak so bad that I started calling the weep hole the pee hole.
If you are into that sort of thing, you can rebuild them with a new bearing and a seal. Rear gasket comes with an engine rebuild set. If you are not then buy a new one, not a rebuilt one.

71-longbed 06-24-2004 03:10 AM

my old water pump off my 350 ... looked like the original... it had a very slllllloooooooowwwww leak out of weep hole .. i replaced it even though it still worked .. you could see the yellow crusty trail down the bottom of the pump .... i wonder how much longer it would of lasted ...it had to be leaking for a few years at least

71-longbed 06-24-2004 03:12 AM

1 Attachment(s)
now you can see the hole :p


All times are GMT -4. The time now is 05:16 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com