The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   700R into 73 C20 (https://67-72chevytrucks.com/vboard/showthread.php?t=111220)

aliencheyenne 07-10-2004 02:03 PM

700R into 73 C20
 
Just finished dropping the 700R into my 3/4 ton. Wanted to let those considering this swap know that my driveshaft was a perfect fit. No shortening and it has about 1" showing on the yoke. I was pleasantly surprised.

bluex 07-10-2004 03:35 PM

What did you do for you linkage?? I can not get mine to go into L1. I'm still using the column linkage. I think I need to make the space on the column under the hood longer?

Thanks
Paul

Jonboy 07-10-2004 06:01 PM

I think that there is a detent in the column itself that will not let it get into 1st.

getfacsw 07-10-2004 08:51 PM

I have to agree, I don't think that you will ever get it into first unless you change the shifter.

I remember reading somewhere that any GM vehicle setup for three foward gears will not get low.

Bill

aliencheyenne 07-11-2004 02:41 AM

I went with a B&M truck floor shifter

plumbcut 07-11-2004 04:50 AM

I have a 700 in my '77 truck. I can get into all gears including 1st, but it took some patience trying to adjust the linkage right. so- it can be done but it obviously wasnt designed for it.

pc

Greenlee 07-11-2004 09:22 AM

Same here. I have a 700R4 in my 76 C-10 and it goes into all of the gears. It just looks a little out of wack because when in its in Drive the indicator on the column looks almost like its in the neutral position.


All times are GMT -4. The time now is 12:28 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Copyright 1997-2025 67-72chevytrucks.com