fs: 1982 k30 parts in MICHIGAN
 

454 engine complete minus ps pump $750
4spd creeper trans w/ np205 tcase $350
(2) rustfree gas tanks with mounting brackets and switch $100
9' flatbed with headache rack and goosneck hookup $600
propane conversion kit (off of bbc) w/ tank $400
floorshift steering column $30

Anyone have rustfree sheetmetal for trade?

how many miles on the 454??? what shape is it in overall??

might be "damn" interested in it

email me at klambert@cebridge.net

-bigarmzz-
:metal:

I do. What are you looking for?

91 suburban/blazer front clip, 81-91 longbox and maybe 81-87 cab and doors. That sounds like one truck, but I am working on a couple trucks. Anywhere close to what you have?

Sorry. I have a 79 clip and cab available. I "built" a 91 front clip, but that is going on my 79 c-10.
I do have 2 door shells, but they need minor repair on the bottoms.
What condition is your column in? is it tilt?

column is tight, not tilt.

k30 parts
 

DUALLY REAR????????????????????? does it have one and what ratio and price. :burnout:

Actually I have a 1977 c30 cab and chassis from Wyoming that has no bed. It has a 4speed tranny (was a bbc truck) and six 16" dually wheels and a 14 bolt rear. I will take $600 for the whole truck. Interior is shot. there is rust in the bottom of the front fenders.

let me know a measurement on the driveshaft from center of U joint to center of Ujoint. one piece or two piece? if available a pic would help. thanx , DAVE

I will be using the rear shaft. I do have others though. What length do you need?

roughly 68" from center of U joint to center of Ujoint. one piece that is and of course it will have the slip joint built in so the measurement is not an exact one. thanx , DAVE

nothing that long. I don't think you can even buy a tube to build one that long.

well the tube itself won't be that long,much shorter, because it's like two separate pieces that the slip-spline is near the front end of it. both ends of mine bolt on the same as the rear normally does. just out of curiousity what does the one out of the 82 measure? DAVE

454
 

What are the numbers on the heads & block ? I have '68-'72 sheetmetal.............Zoomy