finnished dash w/aftermarket gauges
 

can someone direct me to a sight or picks of a mid 70s dash with aftermarket gauges

I saw at least one in this thread...

http://67-72chevytrucks.com/vboard/s....php3?t=156665

dash
 

tkx but Im looking for something around 77

I have three different articles on my site.

One is Mikes, one is mine, and the other is one I found in an older Four Wheeler Magazine...check them out.

http://www.73-87.com/7387garage/garage_interior.htm

Good one Jeff
 

If I was going to customize my interior or had enough engine to warrant the additional gauges, I'd go for that Truckin Mag article. I still might.

-Todd

Todd, good luck with that if you decide to tackle it. If you do, I would love to see the pics and hear how it went. :)

When I saw that article, I was pretty impressed...never seen that done before.

tkx for the info

the only thing I didn't like was cutting up that dash. Must be cause my cheap self has been looking for a nice, crack free dash for quite a while. They don't seem to exist in my area anymore.

Cuttin' a dash
 

Clean dash pads are harder to find than hen's teeth. If I'd go through the effort, I'd have to buy a new one and cut that. The biggest thing holding me back is that I want the truck to look stock. (Believe that? It's because I'm chicken.)

well already started cutting will post pick when finnished.Ty Jeff for your post it helped alot im checkin out the store you got posted on your pg thanks again

No problem dude, anytime. Good luck, and don't forget the pics! :)

Jonboy ,what year dash you looking for ? Frank

will do jeff i got the oil, alt,clock,and fuel ,and speedo in gettin tach soon picks will be in when done

Got dash finished picks are on there way ty Jeff,and everyome else that helped me

I have been loking for an 81-up dash. I have a near perfect bezel, and 87 door panels, so I figured I would go that way.

I don't think a Finnish dash looks any different than ours...there is a Scandinavian board member on here, you can ask him.

This doesn't belong on the parts board, and yes I am being sarcastic.