Vent Window Rebuild?s
 

Can someone run through the procedure for putting new weatherstipping (seal) on the vent windows? Thanks, Brandon

btt

hmmm...
 

i think you want to ask board member 75stepside :metal:

did someone call me up! ya, i've done two sets... check my this page on my site: http://merlin2.alleg.edu/student/t/t...rogress19.html

basically, after the frames are out, just grind off the two rivets on the frame that hold the hinge part on... and that will allow you to pull the glass out of the frame... get out a good set of plyers and yank out the old seal... sandblast, paint, install new seal, and put hinge back together - i used two 5mm bolts instead of the factory rivets.

http://merlin2.alleg.edu/student/t/t...otos/vent1.jpg

http://merlin2.alleg.edu/student/t/t...otos/vent2.jpg

http://merlin2.alleg.edu/student/t/t...otos/vent3.jpg