On HEI for 350
 

DOes anyone know where the #1 is and which way the firing order rotates on the distributor?

Re: On HEI for 350
 

Rotates clockwise. I know there is a "factory" position for #1 but I don't remember what it is. I usually stab the dizzy and find tdc on #1 and start wherever the rotor is pointing.:rolleyes:

Re: On HEI for 350
 

BUt would you happen to know where #1 is on the dist.

Re: On HEI for 350
 

No, sorry. Let me look around, I know it's been posted before.

Re: On HEI for 350
 

http://67-72chevytrucks.com/vboard/s...t=firing+order
Here you go.

Re: On HEI for 350
 

I usually put it next to the where the wiring goes into the cap (to the right of the square part of the cap). But anywhere the rotor points at top dead center is #1!!!! I usually pull the #1 plug and rotate the motor untill the compression blows the finger out (the timing mark will line up with the tab as well) then put the rotor pointing at the #1 plug and set the wires accordingly (clockwise) set the dist housing with enough room to advance and retard the timing without hitting anything as well!!