What are you guys doing about the rust on the inner bedsides??? - Picts inside
 

How have you guys been handling this situation - I know that it is pretty common for these trucks. Luckily the P.O. drilled about 50 1/8" holes under the rear wheel arch - so the outers didn't rust, but the inner panels where it attaches to the wheel house are a little "soft"

What would you do?
This is the Driver's side rear (the worst of it - the pass side only has a couple small holes that can be patched pretty easy)

http://www.arkracingonline.com/photo...1275236383.jpg

Re: What are you guys doing about the rust on the inner bedsides??? - Picts inside
 

What nobody's had this problem?

Did you make a patch? - and how did you do it?

Re: What are you guys doing about the rust on the inner bedsides??? - Picts inside
 

i had to cut out a piece of a boxside that was not rusted on the inside, but was no good on the outside